Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
9
(2) Offline record curve page (as shown in Figure 8), click OK, pop-up clear
confirmation window, you can clear the offline record curve separately.
(3) Select Clear all Records in the settings to clear all records (5 sets
of capacity / power consumption / recording time and voltage and current offline
recording curves). (Enter the follow-up instructions of the setting method)
4.Fast charge identification page (see Figure 5)
Figure 5
description
This page is used to observe the current charging protocol, D + / D- voltage.
Wake Indicates automatic wake-up current, current change≥When Wake, exit from standby.
Bright Represents the current screen brightness.
Instructions
(1) << >> key
Short press: page turning;
(2) OK key
Short press: release D + / D-. When the fast charge trigger state (except the PD protocol), D + /
D- can be released to return to the non-trigger state.
5. Curve display page (as shown in Figures 6, 7, 8)