Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
8
(5) OK key
Short press: When set to manual recording, recording can be paused / started, and it is invalid
when set to automatic recording;
Long press: Clear the current group record data, including capacity, power consumption, and
record valid time.
3.Capacity / power consumption list (see Figure 4)
Figure 4
description
To facilitate the comparative analysis of multiple sets of capacity / power consumption data,
you can switch to the capacity / power consumption list (Figure 4).
Instructions
(1) << key
(2) Long press: Switch to the capacity / power consumption observation page (see Figure 3).
(3) >> key
Short press: switch observation group.
(4) OK key
Short press: When set to manual recording, recording can be paused / started, and it is invalid
when set to automatic recording;
Long press: Clear the current group record data, including capacity, power consumption, and record
valid time.
Method for clearing recorded data
：
(note)
(1) Press the OK button on the pages of Figure 3 and Figure 4 to clear the
capacity, power consumption, and recording time of each group.