Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
29
8.Why does the fast charge protocol automatically detect and
display all red?
Answer: During the test, please do not connect the load. If possible,
test several charging heads. If all the charging heads are all red, and
confirm that these charging heads support fast charging
(QC2.0/QC3.0/FCP/SCP/ Any protocol in AFC/PD), then it is suspected to
be a PCB circuit problem, please check whether the D+D- part is
short-circuited, soldered, etc.