Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
23
Turn on/off the startup page
OK key：Short press: switch the green dot position. Where is the green
dot, which corresponds to which operable block.
Long press: Valid when the green dots are NO/YES.
<< >> key：Short press: change the parameter.
Clear all records: including voltage and current curve, 5 sets of
capacity/power consumption record value.
OK key：Short press: switch the green dot position. Where is the green
dot, which corresponds to which operable block.
Long press: Valid when the green dots are NO/YES.
Restore factory settings: This setting does not clear the recorded
values.
OK key：Short press: switch the green dot position. Where is the green
dot, which corresponds to which operable block.
Long press: Valid when the green dots are NO/YES.
六、 Upgrade firmware instructions
1、 Open the FNIRSI USB Meter upgrade tool.