Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
22
Temperature display symbol: ° C / ° F.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
System language: Chinese / English.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Automatic wake-up current: When the current changes ≥ this value,
it exits the standby state.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Turn on/off software CC pull-down.
OK key：Short press: switch the green dot position. Where is the green
dot, which corresponds to which operable block.
Long press: Valid when the green dots are NO/YES.
<< >> key：Short press: change the parameter.