Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
21
dot, which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Recording time: curve recording time, no recording when NO, range
is 0-9 hours, recording time interval is calculated automatically. (Such
as one hour, one point every 10 seconds)
OK key: short press: switch green dot position. Where is the green
dot, which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Capacity / power consumption record limit: When OFF, the capacity /
power consumption is not limited by the recording time;
When ON, the recording time is up and the capacity / power
consumption is no longer recorded.
OK key: short press: switch green dot position. Where is the green
dot, which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Data transfer switch.
OK key: short press: switch green dot position. Where is the green
dot, which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.