Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
20
<< >> key: short press: when the green dot is at the maximum grid
(20Level, not explained later), change the parameter.
Standby screen display brightness setting, the range is 0-20 level,
when it is 0, the backlight is turned off.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Standby time, ranging from 0-30 minutes. Does not stand by when
OFF.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Automatic recording switch:
ON: recording when the current exceeds the threshold;
OFF: The current threshold is invalid, and recording is started and
stopped by pressing the button.
OK key: short press: switch green dot position. Where is the green
dot, which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.
<< >> key: short press: when the green dot is on the largest grid,
change the parameter.
Current threshold: effective when the automatic recording switch is
ON, current ≥ this value, recording voltage and current equivalent.
OK key: short press: switch green dot position. Where is the green