Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
19
Send：Send Caps broadcast;
Wait：Waiting for voltage request;
Ready：The agreement is complete.
8.System information and setting page (see Figure 18)
Figure 18
description
Press and hold << to power on, FNB38 enters the system information and settings page.
VX.X Indicates the current firmware version.
SN:XXXXXX Indicates the unique serial number of the device.
Run:XXXXXX Represents the number of device runs.
Instructions
(1) << >>key
Short press: switch setting items.
(2) OK key
Short press: The setting window pops up.
Long press: Exit the setting page, and the device starts from the LOGO page.
Setting item description
The screen displays brightness settings, ranging from 1-20 levels.
OK key: short press: switch green dot position. Where is the green dot,
which corresponds to which operational block.
Long press: Effective when the green dots are NO / YES.