Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
18
7.10 PD protocol conversion
This function can convert QC2.0 charging head to PD2.0 charging head for PD
electrical appliances. When entering the page, the system detects whether the
charging head supports QC2.0, if it does not support, it cannot enter.
This function automatically finds power-using equipment and supports 2-60W
broadcasting. You only need to change the power as needed. Be careful not to exceed
the power of the charger to avoid unnecessary damage.
Click the OK button to enter/confirm the power change. You can use the <</>> button
to change the power. After the power is changed, the broadcast will be resent. The
new power protocol is not triggered successfully. Please try to unplug and replug.
It is always 5V when no device is connected, to avoid high-voltage damage to mobile
phones that do not support high-voltage when plugged in.
QC2.0 only has a Class B charger that supports 20V triggering, so when PD
appliances request 20V voltage, the tester will detect whether the charger
successfully triggers QC2.0-20V. If it does not reach 20V, the tester will cancel
the 20V gear. And resend Caps broadcast.
In addition, some PD appliances will change the D+, D+ voltage during charging,
resulting in an abnormal QC2.0 trigger, and this type of charger cannot be charged
by this function.
Figure 22 PDChange page
Status description in the lower right corner：
Find：Looking for PD electrical appliances;