Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
17
(3) >> key
Only valid on the monitoring page 2 (Figure 19), short press: switch to view the detailed
information of the message package; long press to hold to quickly browse down the information.
(4) OK key
Short press: You can switch between page 1 (Figure 18) and page 2 (Figure 19).
Long press: exit the current page.
7.9 PD E-Marker
This function can read the information of the CC line with the chip, use the HID
interface or 5V ordinary power supply (non-Type-C interface power supply), enter PD
E-Marker page 1 (Figure 20), this page shows some parsed CC lines Information, such
as supplier ID, maximum voltage, maximum current, length, etc. Short press >> button
to switch to page 2 (Figure 21), this page displays the unparsed original packet
information, users can parse the packet according to the manual to see if it matches
the data on page 1.
When Auto is green in the upper right corner, it means that the CC line is
automatically detected. At this time, no operation is required when plugging and
unplugging. The cable information will be automatically read. If you click OK to make
Auto gray, you will switch to manual mode. Information will not change. In manual
mode, you can click the << key to obtain the wire information.
Figure 20 Figure 21