Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
14
(2) OK key
Long press: Exit the current page. (Still triggering).
7.5 Huawei SCP trigger
Select Huawei SCP and press OK key to enter the Huawei SCP trigger page (as shown in
Figure 15). Trigger Failure will display Trigger Failure!
Figure 15
Instructions
(1) << >>key
Short press: Decrease / increase SCP trigger voltage.
(2) OK key
Long press: Exit the current page. (At the same time exit the SCP trigger state).
7.6 Samsung AFC trigger
Select Samsung AFC, press OK shortly to enter the Samsung AFC trigger page (as shown in
Figure 16), Fail Failure will display Trigger Failure!
Figure 16
Instructions
(1) << >>key
Short press: switch AFC trigger voltage. (When the charger does not support trigger voltage,