Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
13
7.3 QC3.0 trigger
Select QC3.0, press OK shortly to enter the QC3.0 trigger page (as shown in Figure 13), Fail
Failure will display Trigger Failure!
Figure 13
Instructions
(1) << >>key
Short press: Decrease / increase QC3.0 trigger voltage.
(2) OK key
Long press: Exit the current page. (Still triggering).
7.4 Huawei FCP trigger
Select Huawei FCP and press OK to enter the Huawei FCP trigger page (see Figure 14). If the
entry fails, Trigger Failure! Will be displayed.
Figure 14
Instructions
(1) << >>key
Short press: Switch the FCP trigger voltage.