Manual
Table Of Contents
- 1.Why can't the power reach the maximum power of the
- 2.No agreement can be detected using two cc lines
- 3.Use the tester to trigger fast charge, it cannot
- 4.Why does the PD protocol trigger, when selecting t
- 5.Why does it keep restarting after entering the PD
- 6.Why is the capacity displayed on the tester differ
- 7.The tester automatically restarts when the fast
- 8.Why does the fast charge protocol automatically
10
Figure 6 Figure 7 Figure 8
description
Figure 6 is the real-time curve of voltage and current.
Figure 7 shows the data D + and D- real-time curves.
Figure 8 shows the offline recording curve of voltage and current.
Instructions
(1) << >>key
Short press: page turning;
(2) Long press: Decrease / increase time base. (Only pages in Figures 6 and 7).
(3) OK key
Short press: screenshot curve; (Figures 6 and 7 are valid);
The curve clear window pops up; (Figure 8 is valid);
Long press: switch display curve.
6.Cable measurement page (see Figure 9)
Figure 9
description