Data Sheet

ManualsBrandsDFRobot ManualsEthernetEthernet W5200 Shield for Arduino

iEthernet

W5200

(IR2(S0_IR) = ‘0’). INTn signal becomes High.

d. S0_IR is cleared. As IR2 is not 0x00, INTn should be asserted low right after 1PLL_CLK.

However, as INTLEVEL is 0x000F, the interrupt about IR is processed after I

AWT

(16 PLL_CLK).

IR2(W5200 SOCKET Interrupt Register)[R/W][0x0034][0x00]

IR2 is the Register to notify W5200 SOCKET interrupt to the Host. If any interrupt occurs, the

related bit of IR2 is set as ‘1’. When related Mask Bit is ‘1’, INTn signal is asserted low. INTn

keeps low until all bits of Sn_IR becomes ‘0’. If all bits of Sn_IR become ‘0’, it becomes high

automatically.

7 6 5 4 3 2 1 0

S7_INT S6_INT

S5_INT

S4_INT S3_INT S2_INT S1_INT S0_INT

Bit

Symbol Description

7 S7_INT

When an interrupt occurs at SOCKET 7 , it becomes ‘1’. This interrupt

information is applied to S7_IR. This bit is automatically cleared when

S7_IR is cleared to 0x00 by host.

6 S6_INT

When an interrupt occurs at SOCKET 6 , it becomes ‘1’. This interrupt

information is applied to S6_IR. This bit is automatically cleared when

S6_IR is cleared to 0x00 by host.

5 S5_INT

When an interrupt occurs at SOCKET 5 , it becomes ‘1’. This interrupt

information is applied to S5_IR. This bit is automatically cleared when

S5_IR is cleared to 0x00 by host.

4 S4_INT

When an interrupt occurs at SOCKET 4 , it becomes ‘1’. This interrupt

information is applied to S4_IR. This bit is automatically cleared when

S4_IR is cleared to 0x00 by host.

3 S3_INT

When an interrupt occurs at SOCKET 3 , it becomes ‘1’. This interrupt

information is applied to S3_IR. This bit is automatically cleared when

S3_IR is cleared to 0x00 by host.

2 S2_INT

When an interrupt occurs at SOCKET 2 , it becomes ‘1’. This interrupt

information is applied to S2_IR. This bit is automatically cleared when

S2_IR is cleared to 0x00 by host.

1 S1_INT

When an interrupt occurs at SOCKET 1 , it becomes ‘1’. This interrupt

information is applied to S1_IR. This bit is automatically cleared when

S1_IR is cleared to 0x00 by host.

0 S0_INT

When an interrupt occurs at SOCKET 0 , it becomes ‘0’. This interrupt

information is applied to S0_IR. This bit is automatically cleared when

S0_IR is cleared to 0x00 by host.