Data Sheet

5/5
≤100mΩ
100mΩor less
Push 1Kgf to the shaft of encoder in the axial
4-1.按压寿命
Push-life
修订 Revision 日期 Date 经 办 Designed 审 核 Check 批 准 Approved
初始发行 2014-9-1
版本 VERSION： A0
2-4.耐电压
Dielectric
fore of switch
3-1.开关电路
strength
Operation
number of pulse
3-2.开关动作力
direction
在无负荷条件下沿轴向施以1Kgf以下的力，以600次/小时
4 耐久性能 Endurance Characteristics
Travel of switch
3-3.开关移动量
□1.5±0.5 mm
■0.5±0.3 mm
2.电气性能 Electrical Characteristics
EC11正向系列规格书
EC11 FORWARD DIRECTION SERIES SPECIFICATION
Without arcing or breakdown.
Single pole and single throw
单极单投(按压ON)
Switch circuit and
接点数
在轴端，沿轴向施加的按压力.
在端子和安装板间施加AC300V电压1分钟
A voltage of300V AC shall be applied for 1 minute
500±200gfPush static load to the shaft in the axial
不得有绝缘破坏
3 机械性能 Mechanical Characteristics
between individual terminals and bushing and plank.
（push ON）
备注：以下规格适用于RE11编码器带开关系列.
推动开关部分Push Switch Portion
Measurement shall be made under the condition 100MΩ 以上
规格条件
用DC 5V 1mA 电压测定.
Voltage test at DC 5V 1mA.
SNOITACIFICEPSSNOITIDNOC
2-2.绝缘阻抗
Contact
2-1.接触电阻
ITEM
在端子和安装板间施加电压 250V DC.
resistance
项目
Note：The following specification is only suitable for the one type with switch construction
of RE11 encoder series.
1.额定值 Rating
Maximum operating current (resistive load):10mA Max
1-1.额定电压
Rated voltage:DC 5V
Bouncing
≤10mS
10mS or less
resistance
2-3.振荡
which a voltage of 250V DC is applied between 100MΩ Min
Insulation
■20,000±200次.（0.5行程）
individual terminals and bushing and plank.
以1秒钟1往返(OFF-ON-OFF)按压动作.
Shaft shall be push at 1 cycles/s(OFF-ON-OFF)
1-2.最大额定电流 (阻抗负载)
be satisfied.
Specification in clause shall
.格规期初足满应它其.Ωm002≤:阻电触接.ruoh/semit 006 fo
）levarT 5.0（.selcyc002±000,02。压按度速的
文号 File No
EC11带定位正向专用
□15,000±200次.（1.5行程）
direction under non-load conditions,and with a speed 15,000±200cycles.（1.5 Travel）
受控编号 Document No
Contact resistance:200mΩ or less.