深圳市百斯特电子有限公司
1/5 EC11正向系列规格书 EC11 FORWARD DIRECTION SERIES SPECIFICATION 1.一般事项General 1-1.适用规格 Scope 本规格书适用于微小电流回路的电子设备，属11型回转型编码器. This specification applies to 11mm size low-profile rotary encoder(incremental type) for microscopic current circuits , used in electronic equipment. 1-2.
2/5 EC11正向系列规格书 EC11 FORWARD DIRECTION SERIES SPECIFICATION 5.电气性能 Electrical 项目 ITEM 5-1.输出信号 Output signal format 5-2.分解能力 Resolution Characteristics 条件 规格 CONDITIONS SPECIFICATIONS A、B两信号输出相位差，输出波形详细见（图2/3）(虚线表示带卡点装置的上擎子处位置) 2 Phase-different signals (signal A,signal B) Details shown in (The broken line shows detent position.) 输出波形 轴回转方向 信号 Shaft rotatiSignal Output onal direction 图2 fig.2 图3 fig.3 A(A-C端子间) 顺时针方向 A(TerminalA-C) C.
3/5 EC11正向系列规格书 EC11 FORWARD DIRECTION SERIES SPECIFICATION 5-3-3.滑动噪音 Sliding noise 5-4.相差位 Phase difference 编码OFF部份的电压变动。 The voltage change in code-OFF area. 下（图6）所示回路，轴以360°/S的速度转动测定。 Measurement shall be made under the condition which the shaft is rotated at 60r/min T A信号(A～C间) OFF signal A 图6 fig.6 ON 3.5V以上 3.5Vmin T1、T2、T3、T4≥0.08T 见图6 (fig.6) OFF B信号(B～C间) signal B T1 T2 T3 T4 ON C.
4/5 EC11正向系列规格书 EC11 FORWARD DIRECTION SERIES SPECIFICATION 7 耐久性能 Endurance Characteristics 项目 ITEM 7-1.回转寿命 Rotational life 7-2.耐湿性 Damp heat 7-3.耐热性 Dry heat 7-4.低温特性 Cold 7-5.焊锡耐热性 Resistance to Soldering heat 7-6.焊锡性 Solderability 条件 CONDITIONS 在无负荷条件下轴以600～1000周/小时速度回转， 一日连续5000～8000次. The shaft of encoder shall be rotated at a speed of 600～1000cycles/H without electrical load,after with measurements shall be made. (5000 to 8000 continuous cycles for 24 hours.
5/5 EC11正向系列规格书 EC11 FORWARD DIRECTION SERIES SPECIFICATION 推动开关部分Push Switch Portion 备注：以下规格适用于RE11编码器带开关系列. Note：The following specification is only suitable for the one type with switch construction of RE11 encoder series. 1.额定值 Rating 1-1.额定电压 Rated voltage:DC 5V 1-2.最大额定电流 (阻抗负载) Maximum operating current (resistive load):10mA Max 2.电气性能 Electrical 项目 ITEM 2-1.接触电阻 Contact resistance 2-2.绝缘阻抗 Insulation resistance 2-3.振荡 Bouncing 2-4.
