Manual

9
2.2 Loop of Programming
The philosophy of programming parameters has been
shown on the flow chart of 2.1. Basically user should
1. Sca n Start of Configuration.
2. Sca n all ne cessary labels for para meters that meet
applications.
3. Scan End of Configuration to end the
programming.
4. To permanently save the settings you
programmed, just scan label for Save Parameters.
5. To go back to the Default Settings, just scan la bel
f or Set All Defaults.
2.3 Factory Default Settings
The fa ctory default settings are shown with < > and
bold in the following sections. You can make your
own settings by following the procedures in this
ma nual. If you wa nt to save the settings permanently ,
you should scan the label of "Save Parameters" in
chapter 2.4, otherwise the settings will not be saved
after the decoder power is off, and all settings will go
back to previous settings.
By scanning "Set All Default" label, the settings will
go back to the factory default settings.