User`s manual

Hardware Installation

Chassis Intrusion Connector

The board supports the chassis intrusion detection function. Connect the chas-

sis intrusion sensor cable from the chassis to this connector. When the system’s

power is on and a chassis intrusion occurred, an alarm will sound. When the

system’spower is off and a chassis intrusion occurred, the alarm will sound only

whenthesystemrestarts.

MyGuard Hardware Monitor

Install the “MyGuard Hardware Monitor” utility. By default, the chassis intrusion

detection function is disabled. When enabled, a warning message will appear

when the chassis is open. The utility can also be congured so that a beeping

alarm will sound when the chassis is open. Refer to the “MyGuard Hardware

Monitor”sectioninchapter4formoreinformation.

Chassis

signal

Ground

1 2