User`s manual

2
Hardware Installation
15
2.3 DIP Switch Settings for Processors
The table on the next page shows the supported processors and
their corresponding DIP switch settings (SW1). There are 4 switches
on SW1. The black rectangle in the diagram denotes the part that is
protruding, the adjustable switch. Make sure SW1 is set correctly
before applying power, otherwise you will not be able to power-on
the system.
1. Pull the tabs which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the notches in the
module aligned with the keys on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.
In the example above:
Switch 1: Off
Switch 2: Off
Switch 3: On
Switch 4: On