User`s manual

22
2
Hardware Installation
2.6.4 Floppy Disk Drive Controller
1. Install the 34-pin header
connector into the shrouded
floppy disk header (J8) on the
system board. The colored
edge of the ribbon should be
aligned with pin 1 of connector
J8.
2. Install the other 34-pin header
connector(s) into the disk
drive(s). Align the colored edge
of the daisy chained ribbon
cable with pin 1 of the drive edge connector(s). The end-most
connector should be attached to the drive you want to
designate as Drive A.
2.6.5 IDE Hard Disk Interface
1. If you are connecting two
hard drives, install the 40-pin
connector of the IDE cable
into the primary shrouded
IDE header (connector J9). If
you are adding a third or
fourth IDE device, install the
40-pin connector of the other
IDE cable into the secondary
shrouded IDE header
(connector J10).
2. Install the other 40-pin header connector(s) into the device with
the colored edge of the ribbon cable aligned with pin 1 of the
drive edge connector(s).
Note:
Refer to your disk drive users manual for information about
selecting proper drive switch settings.