User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
86
3
BIOS Setup
4. When the Password Installed dialog box appears, select OK.
To change the password, repeat the same steps above.
After you have set the user password, the Clear User Password and Password
Check elds will appear.
Clear User Password
To clear the password, select Clear User Password then press <Enter>. Click OK.
Install or Change the
password.
BIOS SETUP UTILITY
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Security
Security Settings
Supervisor Password : Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Password Installed
[OK]
BIOS SETUP UTILITY
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
Security
Security Settings
Supervisor Password : Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Clear User Password
Password Check
Clear User Password?
[OK] [Cancel]
Immediately clears the
User password.
← → Select Screen
↑↓ Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit