User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
82
3
BIOS Setup
Security
Install or Change the
password.
BIOS SETUP UTILITY
ExitChipset
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Main Advanced PCIPnP
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Boot Security
Change Supervisor Password
This eld is used to set or change the supervisor password. To set a new pass-
word:
1. Select the Change Supervisor Password eld then press <Enter>.
2. Type your password in the dialog box then press <Enter>. You are limited to
eight letters/numbers.
Install or Change the
password.
BIOS SETUP UTILITY
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Security
Enter New Password