User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
56
2
Hardware Installation
3. While supporting the mounting screw at the bottom, from the top side of the
board, fasten a bolt into the screw.
Bolts
4. Grasping the XLT0-2C1G2U by its edges, position it on top of the LR102
board with its mounting holes aligned with the bolts on the LR102. This will
also align the two boards to each other.
Daughterboard Connector