User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
55
2
Hardware Installation
Installing the XLT0-2C1G2U onto the LR102 (op-
tional)
Important:
The carrier board used in this section is for reference purpose only.
These illustrations are mainly to guide you on how to install the XLT0-
2C1G2U onto the LR102 of your choice.
2. Insert the provided mounting screws into the mounting holes - from the bot-
tom through the top of the carrier board.
Mounting screws
1. The photo below shows the locations of the mounting holes.
Mounting hole