User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
27
2
Hardware Installation
Power-on Select
JP11 is used to select the method of powering on the system. If you want the
system to power-on whenever AC power comes in, set JP11 pins 2 and 3 to On.
If you want to use the power button, set pins 1 and 2 to On.
When using the JP11 “Power On” feature to power the system back on after a
power failure occurs, the system may not power on if the power lost is resumed
within 5 seconds (power icker).
Note:
In order to ensure that power is resumed after a power failure that re-
covers within a 5 second period, JP11 must be set to pins 2-3 and the
“PWRON After PWR-Fail” in CMOS is set to “On”.
1-2 On:
Power-on via
power button
(default)
2-3 On:
Power-on via
AC power
JP11
13 2
13 2