User`s manual
Table Of Contents
- Copyright
- Trademarks
- FCC and DOC Statement on Class B
- Table of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - NLITE and AHCI Installatoin Guide
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
23
2
Hardware Installation
LVDS Panel Power Select
J6
J6 is used to select the power supplied to the LCD panel.
Important:
Before powering-on the system, make sure the J6 setting matches the
LCD panel’s specication. Selecting the incorrect voltage will seriously
damage the LCD panel.
3-4 On: 5V
1
3
5
2
4
6
1
3
5
2
4
6
5-6 On: 3.3V
(default)
1-2 On: 12V
1
3
5
2
4
6