User`s manual

BIOS Setup

3.1.4.6 Init Display First

This field is used to select whether to initialize the AGP or PCI first

when the system boots.

Onboard/AGP When the system boots, it will first initialize the

AGP.

PCI Slot When the system boots, it will first initialize PCI.

3.1.4.7 OnChip USB

This field is used to enable or disable USB 1.1 and/or USB 2.0.

3.1.4.8 USB KB/Storage Support

If you are using a USB keyboard or USB storage devices, set this

field to Enabled.

3.1.4.9 USB Mouse Support

If you are using a USB mouse, set this field to Enabled.

3.1.4.10 IDE DMA Transfer Access

This field is used to enable or disable the DMA transfer function of

an IDE hard drive.

3.1.4.11 IDE HDD Block Mode

Enabled The IDE HDD uses the block mode. The system BIOS

will check the hard disk drive for the maximum block

size the system can transfer. The block size will depend

on the type of hard disk drive.

Disabled The IDE HDD uses the standard mode.

3.1.4.12 Power On By Button

Set this field to Enabled if you are using the power button to

power-on the system.