User`s manual

39
2
Hardware Installation
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
Driver Installation
Install the “Audio Drivers”. An audio software application program
will at the same time be installed into your system. Refer to chapter
4 for more information.
Rear Right/Left Jack (Black)
This jack is used to connect to the rear right and rear left speakers
of the audio system.
Side Right/Left Jack (Gray)
This jack is used to connect to the side left and side right speakers
of the audio system.
Front Audio
The front audio connector (J2) allows you to connect to the line-out
and mic-in jacks that are at the front panel of your system. Using
this connector will disable the rear audio’s line-out and mic-in func-
tions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J2 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of J2. If you are not using this
connector, make sure to replace the jumper caps back to their
original pin locations.