User`s manual

BIOS Setup

3.1.5.6 Soft-Off by PBTN

This field allows you to select the method of powering off your

system.

Delay 4 Sec. Regardless of whether the Power Management

function is enabled or disabled, if the power but-

ton is pushed and released in less than 4 sec, the

system enters the Suspend mode. The purpose of

this function is to prevent the system from

powering off in case you accidentally “hit” or

pushed the power button. Push and release again

in less than 4 sec to restore. Pushing the power

button for more than 4 seconds will power off

the system.

Instant-Off Pressing and then releasing the power button at

once will immediately power off your system.

3.1.5.7 Wake On LAN from Soft-Off

If you are using a LAN card that supports the remote wake up

function, set this field to Enabled. The will allow the network to

remotely wake up a Soft Power Down (Soft-Off) PC. However, if

your system is in the Suspend mode, you can wake up the sys-

tem only through an IRQ or DMA interrupt.

3.1.5.8 Wake On Ring from Soft-Off

When this field is set to Enabled, the system will power-on to re-

spond to calls coming from an external modem.

3.1.5.9 USB Resume From S3

This field, when enabled, allows you to use a USB device to wake

up a system that is in the S3 (STR - Suspend To RAM) state.