User`s manual

BIOS Setup

EPP Mode Select

This is used to select the EPP mode.

ECP Mode Use DMA

This is used to select the DMA channel of the parallel port.

3.1.4.4 Init Display First

This field is used to select whether to initialize the AGP or PCI

first when the system boots.

Onboard/AGP When the system boots, it will first initialize

the AGP.

PCI Slot When the system boots, it will first initialize

PCI.

3.1.4.5 OnChip USB Control

This field is used to enable or disable USB 1.1 and/or USB 2.0.

3.1.4.6 USB Keyboard Support

By default, USB Keyboard Support is Disabled. However, if you

are using a USB keyboard under DOS, make sure to enable this

function.

3.1.4.7 IDE HDD Block Mode

Enabled The IDE HDD uses the block mode. The system

BIOS will check the hard disk drive for the maximum

block size the system can transfer. The block size will

depend on the type of hard disk drive.

Disabled The IDE HDD uses the standard mode.