User`s manual

Hardware Installation

2.6.2 IEEE 1394

The system board is equipped with three IEEE 1394 connectors

at locations J5 (1394_1), J7 (1394_2) and J9 (1394_3) for con-

necting 1394 ports. One of these connectors allows you to con-

nect to the IEEE 1394 port that is on the FrontX device. (The

FrontX device, which comes with LANPARTY series products,

must be installed into a drive bay of the chassis.) Connect the

IEEE 1394 cable connector from FrontX to J5, J7 or J9. Make sure

pin 1 of the cable connector is aligned with pin 1 of J5, J7 or J9.

One card-edge bracket, mounted with 2 IEEE 1394 ports, is in-

cluded in the system board package. Install the card-edge bracket

to the system chassis then connect the cable connector to the

IEEE 1394 connector on the system board. Make sure pin 1 of

the cable connector is aligned with pin 1 of J5, J7 or J9. Now

connect your IEEE 1394 devices to the ports that are on the

bracket.

BIOS Setting

Enable or disable the onboard IEEE 1394 in the Genie BIOS Set-

ting of the BIOS. Refer to chapter 3 for more information.

1394_2

1394_31394_1

TPA+

TPA-

Ground

TPB- TPB+

VCC VCC

KeyShield