User`s manual

36
2
Hardware Installation
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
• Line-out Jack (Lime)
This jack is used to connect external speakers for audio output
from the system board. Using this jack disables the front au-
dio’s line-out function.
Center/Bass and Rear Out Jacks
Center/Bass and Rear Out Jacks (CN4) support 4 audio output
signals: center channel, subwoofer, rear right channel and rear left
channel. These 4 audio output signals together with the line-out
(2-channel) jack support 6-channel audio output.
Front Audio
The front audio connector (J4) allows you to connect to the
line-out and mic-in jacks that are on the FrontX device. Using the
line-out and mic-in jacks will disable the rear audio’s line-out and
mic-in functions. (The FrontX device, which comes with
LANPARTY series products, must be installed into a drive bay of
the chassis.)
Remove the jumper caps from pins 5-6 and pins 9-10 of J4 prior
to connecting the front audio cable connector. Make sure pin 1
of the cable connector is aligned with pin 1 of J4. If you are not
using this connector, make sure to replace the jumper caps back
to their original pin locations.