User`s manual

Hardware Installation

Wake-On-USB

The Wake-On-USB function allows you to use a USB device to

wake up a system from the S3 (STR - Suspend To RAM) state. To

use this function:

• BIOS Setting:

“USB Resume From S3” in the Power Management Setup

submenu of the BIOS must be set to Enabled. Refer to chap-

ter 3 for more information.

Important:

• If you are using the Wake-On-USB function for 2 USB ports,

the 5VSB power source of your power supply must support

≥

1.5A.

• If you are using the Wake-On-USB function for 3 or more

USB ports, the 5VSB power source of your power supply

must support

≥

2A.