User`s manual

Hardware Installation

2.5.6 Universal Serial Bus Ports

USB 2

USB 1

Four onboard USB 2.0/1.1 ports (Black) are at locations CN7

(USB 1-2) and CN8 (USB 3-4) of the system board.

The J13 (USB 5-6) connector allows you to connect to the 2

USB ports that are on the FrontX device. (The FrontX device,

which comes with LANPARTY series products, must be installed

into a drive bay of the chassis.) Connect the USB cable connec-

tor from FrontX to J13. Make sure pin 1 of the cable connector

is aligned with pin 1 of J13.

BIOS Setting

Configure the onboard USB in the Integrated Peripherals

submenu of the BIOS. Refer to chapter 3 for more information.

Driver Installation

You may need to install the proper drivers in your operating

system to use the USB device. Refer to your operating system’s

manual or documentation for more information.

USB 5-6

210

VCC VCC

-Data

+Data

Ground

KeyN. C.

USB 4

USB 3