User`s manual

Introduction

Wake-On-LAN

This feature allows the network to remotely wake up a Soft

Power Down (Soft-Off) PC. It is supported via the onboard LAN

port or via a PCI LAN card that uses the PCI PME (Power Man-

agement Event) signal. However, if your system is in the Suspend

mode, you can power-on the system only through an IRQ or

DMA interrupt.

Important:

The 5VSB power source of your power supply must support

≥

720mA.

Wake-On-PS/2 Keyboard/Mouse

This function allows you to use the PS/2 keyboard or PS/2

mouse to power-on the system.

Important:

The 5VSB power source of your power supply must support

≥

720mA.

Wake-On-USB

This function allows you to use a USB device to wake up a

system from the S3 (STR - Suspend To RAM) state.

Important:

• If you are using the Wake-On-USB function for 2 USB ports,

the 5VSB power source of your power supply must support

≥

1.5A.

• If you are using the Wake-On-USB function for 3 or more

USB ports, the 5VSB power source of your power supply

must support

≥

2A.

RTC Timer to Power-on the System

The RTC installed on the system board allows your system to

automatically power-on on the set date and time.