User`s manual

37
2
Hardware Installation
USB Ports
The system board supports 8 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
Four onboard USB 2.0/1.1 ports (Black) are at locations CN6 (USB
1-2) and CN5 (USB 3-4) of the system board.
J10 (USB 5-6) and J11 (USB 7-8) allow you to connect 4 additional
USB 2.0/1.1 ports. Your USB ports may come mounted on a card-
edge bracket. Install the card-edge bracket to an available slot at the
rear of the system chassis then insert the connector that is attached
to the USB port cables to J10/J11. Make sure pin 1 of the cable
connector is aligned with pin 1 of J10/J11.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
(“Onboard Device” section) of the BIOS. Refer to chapter 3 for
more information.
W
USB 5-6
USB 4
USB 3
1
VCC
-Data
+Data
GND
Key
VCC
-Data
+Data
GND
N. C.
2
10
9
USB 2
USB 1
W
W
USB 7-8