User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Enabling Hyper-Threading Technology
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
44
2
Hardware Installation
S/PDIF-out Connector
The S/PDIF-out connector (J6) is used to connect an external
S/PDIF-out port. Your S/PDIF-out port may be mounted on a card-
edge bracket. Install the card-edge bracket to an available slot at the
rear of the system chassis then connect the audio cable connector to
J6. Make sure pin 1 of the audio cable connector is aligned with pin
1 of J6.
15
+5V
Key
SPDIF out
GND
N. C.
W