User`s manual
Table Of Contents
- About this Manual
- Warranty
- Static Electricity Precautions
- Safety Measures
- About the Package
- Before Using the System Board
- Chapter 1 - Introduction
- Chapter 2 - Hardware Installation
- Chapter 3 - BIOS Setup
- Chapter 4 - Supported Software
- Appendix A - Enabling Hyper-Threading Technology
- Appendix B - Watchdog Timer
- Appendix C - System Error Message
- Appendix D - Troubleshooting
25
2
Hardware Installation
2. Place the heat sink on top of the CPU. The 4 studs around the
heat sink which are used to secure the heat sink onto the sys-
tem board must match the 4 mounting holes around the socket.
Position each stud so that the groove faces the heat sink then
push it down firmly until it clicks into place.
Note:
You will not be able to secure the fan and heat sink as-
sembly in place if the groove is not facing the heat sink.
3. Connect the CPU fan’s cable connector to the CPU fan connec-
tor on the system board.
Mounting
hole
Mounting
hole
Mounting
hole
Mounting
hole
Heat sink
Fan
Stud
Groove