User`s manual

Green PCI/VL-B/ISA System Board
Installing the PS/2 Mouse Port
The G586VPA package includes a DB-25S hole cover
which contains the PS/2 mouse port attached to a ribbon
cable.
To install:
1. Use the two screws provided with the package to
secure the DB-25S hole cover to the DB-25S hole
normally found at the rear of a system chassis.
2. Connect the cable to Connector CN2 of the system
board.
Note:
Make sure that the jumper J18 is set to Enabled
(pins 1-2 On). For more information, refer to page
2-9.
2-29 u Installation Overview