User`s manual

G586SP/G586SP AIO

1. Locate the 160-pin cache module slot on the system

board. Position the cache module above the slot. Make sure

pin 1 of the cache module is aligned with pin 1 of the slot.

Carefully slide the module into the slot. Press firmly on top

of it to seat it properly.

Note: Do not use 5V SRAM as they will not function properly. You

must first remove the onboard SRAM and/or TAG SRAM and select

the appropriate module type on JP14 before installing the cache

module.

Cache Configuration

The system board supports 3.3V pipelined burst or asynchro-

nous cache SRAM installed in the 160-pin cache module

slot. The board can be configured to the following cache

sizes: 256KB, 512KB, or 1MB.

Installing the Cache Module (see page 8 for slot location)

2. Once the cache module has been installed, make sure the

“External Cache” option in the “BIOS Features Setup” menu

of the Award PnP BIOS CMOS Setup Utility is set to

“Enabled”.

Note: With the cache module installed in the cache module slot,

the length of the add-on card in PCI Slot 4 is limited to 205 mm

only if its components protrude more than 5 mm from the

components and/or solder side of the card.