User`s manual

G586SP/G586SP AIO
11
Jumper JP5 (G586SP AIO): Onboard VGA Interrupt
Jumper JP2: Display Type Select
Jumper JP2 sets the display adapter to color or mono. The
default setting is ON which is on the color mode. This jumper
must match the type of display adapter installed. If you change
your video adapter, make sure this jumper is changed accord-
ingly.
Jumper JP3: PS/2 Mouse
Board Configuration
Jumper Settings: For jumper locations, see System Board Layout on
page 8
Jumper JP12: Password/CMOS Clear
You can use the CMOS Clear function to return the CMOS back
to defaults and to reset your password if you set a password in
the CMOS “Password Setting” option and forget your password.
To reset your password, first power off the computer and set pin
2-3 to the “On” position. Wait at least one minute, then set pin
1-2 to “On” and turn on your computer. Now the password has
been cleared and the CMOS has returned to the default. You
may enter a new password and/or change to new settings.
Note: (1) Enable VGA interrupt only when using VGA Feature Con-
nector; (2) By enabling JP5, you will lose INTA# of PCI 1 slot.
JP3
Enable (Default) On
Disable Off
JP5
Enable * (Use VGA Feature Connector)
On
Disable (Default) Off