User`s manual

Video Off Method

This determines the manner in which the monitor is blanked.

This selection will cause the system to turn off the vertical and

horizontal synchronization ports and write blanks to the video

buffer.

This option only writes blanks to the video buffer.

Initializes display power management signaling.

V/H

SYNC +

Blank

Screen

DPMS

MODEM Use IRQ

This category is used to set an IRQ channel (IRQ 3, 4, 5, 7, 9, 10 or

11) for the modem installed in your system.

Doze Mode, Standby Mode, Suspend Mode and HDD Power Down

These Green PC power saving categories are user configurable only

when the Power Management category is set to User Defined.

Doze

Mode

Standby

Mode

Suspend

Mode

HDD

Power

Down

When enabled and after the set time of system inactivity, the

CPU clock will run at a slower speed (1/2 of full speed) while

all other devices still operate at full speed.

When enabled and after the set time of system inactivity, the

CPU clock will run at a speed slower than the speed during

Doze mode (1/3 of full speed) while all other devices still oper-

ate at full speed.

When enabled and after the set time of system inactivity, the

CPU and onboard peripherals will be shut off.

This is used to define the continuous HDD idle time that

elapses before the HDD enters the power saving mode (motor

off). When enabled and after the set time of system inactivity,

the hard disk drive will be powered down while all other de-

vices remain active.