User`s manual

DISPLAY TYPE HAS CHANGED SINCE LAST BOOT

Since last powering off the system, the display adapter has been

changed. You must configure the system for the new display type.

ERROR ENCOUNTERED INITIALIZING HARD DRIVE

The hard drive cannot be initialized. Be sure all cables are correctly and

firmly attached. Also, be sure the correct hard drive type is selected in

Setup.

ERROR INITIALIZING HARD DISK CONTROLLER

The system cannot initialize the controller. Be sure the correct hard

drive type is selected in Setup. Also, check to see if any jumper needs

to be set correctly on the hard drive.

FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT

The system cannot find or initialize the floppy drive controller. If no

floppy drive is installed, be sure the Diskette Drive selection in Setup is

set to NONE.

KEYBOARD ERROR OR NO KEYBOARD PRESENT

Cannot initialize the keyboard. Make sure the keyboard is attached cor-

rectly and no keys are being pressed during the boot.

If you are purposely configuring the system without a keyboard, set the

error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. This

will cause the BIOS to ignore the missing keyboard and continue the

boot.

MEMORY ADDRESS ERROR AT...

Indicates a memory address error at a specific location. You can use

this location along with the memory map for your system to find and

replace the bad memory chips.

MEMORY SIZE HAS CHANGED SINCE LAST BOOT

Memory has been added or removed since the last boot. Enter Setup

and enter the new memory size in the memory fields.

MEMORY VERIFY ERROR AT...

Indicates an error verifying a value already written to memory. Use the

location along with your system’s memory map to locate the bad chip.