User`s manual

42
To delete or disable the password function, highlight “Supervisor Pass-
word” and press <Enter>, instead of typing in a new password. Press
the <Esc> key to return to the main menu.
If you forget your password, you should clear any previously set pass-
word by setting Jumper JP3 to On for approximately two minutes.
Please refer to page 21 for more information.
User Password
If you want another user to have access only to your system but not to
setup, set a user’s password with the “System” option selected in the
BIOS Features Setup.
If you want a user to enter a password when trying to access setup, set
a user’s password with the “Setup” option selected in the BIOS Fea-
tures Setup. Using user’s password to enter Setup allows a user to
access only the “User Password” option that appears on the main
screen. Access to all other options is denied.
To set, confirm, verify, disable or delete a user’s password, follow the
procedures described in the section “Supervisor Password”. If you for-
get your password, refer to the procedure described in the same sec-
tion.
IDE HDD Auto Detection
This option detects the hard disk parameters for the hard disk drives
installed in your system. Highlight this option and press <Enter>. A
screen similar to the one on the next page will appear.