User`s manual

51
2
Hardware Installation
Chassis Open Connector
W
The system board supports the chassis intrusion detection func-
tion. To use this function, connect the chassis intrusion sensor
cable from the chassis to J1. Whenever a chassis component has
been removed, the sensor sends signal to J1 alerting you of a
chassis intrusion event. To disable this function, place a jumper
cap over J1.
Hardware Doctor Utility
Install “Hardware Doctor”. By default, the chassis intrusion detection
function is disabled. When enabled, a warning message will appear
when the chassis is open. The utility can also be configured so that a
beeping alarm will sound when the chassis is open. Refer to the
“Hardware Doctor” section in chapter 4 for more information.
12
Ground
Chassis
signal