User`s manual

36
2
Hardware Installation
Universal Serial Bus Ports
The system board supports USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of
simultaneously accessible external Plug and Play peripherals.
The 4 onboard USB 2.0/1.1 ports (Black) are at locations CN5
(USB 0-1) and CN6 (USB 2-3).
J10 (USB 4-5) allows you to connect 2 additional USB 2.0/1.1 ports.
The USB ports may be mounted on a card-edge bracket. Install the
card-edge bracket to the system chassis then insert the connector
that is attached to the USB port cables to J10.
BIOS Setting
Configure USB in the Integrated Peripherals submenu of the BIOS.
Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system
to use the USB device. Refer to your operating system’s manual or
documentation for more information.
Refer to chapter 4 for more information about USB 2.0 drivers.
USB 3
USB 2
W
W
USB
4-5
W
1
VCC
-Data
+Data
Ground
Key
VCC
-Data
+Data
Ground
N. C.
2
10
9
USB 1
USB 0