User`s manual

Introduction

Wake-On-Ring

This feature allows the system that is in the Suspend mode or Soft

Power Off mode to wake-up/power-on to respond to calls coming

from an external modem, internal modem or respond to calls from a

modem PCI card that uses the PCI PME (Power Management

Event) signal to remotely wake up the PC.

Important:

If you are using a modem add-in card, the 5VSB power source

of your power supply must support a minimum of

≥

720mA.

Wake-On-LAN

This feature allows the network to remotely wake up a Soft Power

Down (Soft-Off) PC. It is supported via the onboard LAN port, via

a PCI LAN card that uses the PCI PME (Power Management Event)

signal or via a LAN card that uses the Wake-On-LAN connector.

However, if your system is in the Suspend mode, you can power-on

the system only through an IRQ or DMA interrupt.

Important:

The 5VSB power source of your power supply must support

≥

720mA.

Wake-On-PS/2 Keyboard/Mouse

This function allows you to use the PS/2 keyboard or PS/2 mouse

to power-on the system.

Important:

The 5VSB power source of your power supply must support

≥

720mA.