User`s manual

44
2
Hardware Installation
1
LAN
Power Connector
Insert a 10-pin connector from the power supply unit to the power
connector on the system board. We recommend that you use a
power supply that complies with the ATX12V Power Supply Design
Guide Version 1.1.
Important:
The system board consumes a minimal amount of power. Due
to its low power consumption, you only need a
100W to100W to
100W to100W to
100W to
150W150W
150W150W
150W power supply. Every power supply has its minimum
load of power. If you use a greater than 150W power supply,
the power consumed by the system board may not attain its
minimum load causing instability to the entire system.
X
3.3V
1
5
6
10
GND
5VSB GND
+12V
3.3V
PON-
GND
+5V
+5V