User`s manual

62
3
Award BIOS Setup Utility
AC97 Modem
Auto Select this option when using a primary or secondary
modem riser card, or audio/modem riser card.
Disabled Select this option when using a PCI modem card.
IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system BIOS
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
Disabled The IDE HDD uses the standard mode.
Keyboard/Mouse Power On
This field allows you to use the keyboard or PS/2 mouse to power-
on the system. To use this function, make sure JP5 is set to 2-3 On -
the Wake-On-Keyboard/Mouse function enabled. Refer to Jumper
Settings for Wake-On-Keyboard/Wake-On-Mouse in chapter 2 for
more information.
Disabled Default setting.
Warning:
If JP5 was previously enabled with a pass-
word set in the KB Power On Password field,
and now you wish to disable the keyboard
password function, make sure to set this field
to disabled prior to setting JP5 to disabled
(1-2 On). You will not be able to boot up the
system if you fail to do so.
Password When this option is selected, move the cursor to
the KB Power On Password field and press
<Enter>. Enter your password. You can enter up to
5 characters. Type in exactly the same password to
confirm, then press <Enter>.
Important:
The power button will not function once a
keyboard password has been set in the KB
Power On Password field. You must type the
correct password to power-on the system. If
you forgot the password, power-off the