User`s manual

2
Hardware Installation
43
2.10.17 Chassis Open Connector
The chassis open function, when enabled, will alert you that the
system chassis is open. To use this function, please follow the steps
below.
1. Connect the chassis sensor cable that is attached on your
system chassis to location J3 on the system board.
2. Install the Hardware Doctor utility contained in the provided
CD. By default, this function is disabled. When enabled, a warning
message will appear when the chassis is open. The utility may
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the Hardware Doctor section in
chapter 4 for instructions on installing the utility.
Pin
1
2
3
4
Function
Ground
Chassis signal
N. C.
+5V